Introduction to Linux II

The routing table shows an entry with genmask 0.0.0.0, this indicates the _____. Default Name...

The kernel’s routing table contains static and dynamic routes. True or False? True False

Which command is used to find the netmask of the eth0 interface? ifconfig -eth0 ifconfig -A...

Which command is used to assign a netmask to the eth1 interface? ifconfig eth1 submask 255.255.255...

The ifconfig will accept an interface name as an argument. True or False? True False

Which file contains host and routing details of all configured network interfaces for Red Hat based...

What type of interface is a network interface card? Software interface Proxy interface Hardware...

The /etc/nsswitch.conf file defines the order in which DNS and the /etc/hosts file are queried for...

Which file is referred to by the Name Service Switch (NSS) resolver? /etc/nssconfig.conf /etc/hosts...

Which of the configuration directives given below is not found in the /etc/resolv.conf file...

Which configuration file is referred to for DNS resolution? /etc/dns.conf /etc/names.conf...

The _____ command is used to view the fully qualified domain name of the host. hostname cat...

Which file is referred to on systems where DNS is not set up? /etc/network-hosts /etc/host-config...

The system administrator tries to assign the value host*2014@SNG using the hostname command. What...

Which protocol does the Echo Reply/Request (ping) message use? UDP TCP ICMP IP